SmartSpeed Pro - Changing channel

SmartSpeed Pro timing units need to be on the same channel as the SmartHub.

If your timing units have been used with a different SmartHub, you may need to change the channel of your timing units.

To set your timing units on the same channel as a SmartHub:
  1. There is a cursor on the SmartHub LCD display (small black square). Note where the cursor is by pressing Scroll.
  2. Scroll SmartHub cursor to RF Channel
  3. Press Enter
  4. Scroll to select a channel
  5. Press Enter to confirm your channel selection (e.g. 0x0D)
SmartHub will display ‘ Configuring RF Parameter – Please Wait’ message. Once this message disappears, your selected channel will be displayed, and your timing units should be on the same channel as SmartHub.