SmartSpeed Drill - One-Way Timing

Overview:

A One-Way Timing drill is defined as a drill with a defined start and separate defined finish where the athlete does not move back through a beam they have already broken once.  

A minimum of 2 SmartSpeed timing gates are required, but additional gates can be added to allow for additional spilt time collection.  

This protocol can also be described as a linear sprint drill, although the set up does not necessarily need to be linear.

Minimum number of timing gates: 2

Suitable for SmartSpeed Pro and SmartSpeed Dash

To setup in SmartSpeed app:

1. Log in to SmartSpeed app
2. Select Start Session
3. If required, set up an additional track (lane) if you have 4 or more gates
4. Select Drill: One-way Timing
5. Select My Drill: Standard (unless using a custom drill created in SmartSpeed Online)
6. Select your Team
7. Select Mode: Automatic (unless using SmartScan RFID reader)
8. Confirm Re-arm: 500 ms. The time is takes for gates to reset for the next athlete - adjust as required
9. Name session as required for your reporting
10. Select Ready
11. Set the timing gate order. Walk through the timing gates in the order the athlete will pass through.
12. Confirm the order of the timing gates displayed on screen
13. Select Start
14. Select ECP: On
15. Select your Start Type:
16. Set your Split Distance. This is the distance from gate 1 to gate 2, gate 2 to gate 3, gate 3 to gate 4 etc.
17. Select your Tag Result preference. If you select On, you then select the amount of time you have to tag a result valid or invalid.
18. Select the Tick Icon 
19. Run through the drill as configured