Setting up your HumanTrak Kit Kinect v2

What's in the case?

Hard Carry Case Custom HumanTrak Laptop Laptop Charger Cable + Brick Tripod
Kinect 3D Infrared Camera Kinect Adapter Kit
 		HumanTrak USB Receiver
 		4x HumanTrak IMU Sensors
(2x Wrist, 2x Ankle)
Spare IMU Wrist/Ankle Straps
 4x IMU USB Charger Cables
 IMU Charger Hub

Charging the IMU Sensors

1
Connect the USB Charger Power Cable with the USB Charger Hub   
2
Connect the USB Charger Power Cable to a wall socket
3

Connect 4 x USB Cables to the USB Charging Hub

 
4
Connect 4 x IMU Sensors to the USB Charging Hub  
5
LED lights on each IMU Sensor will illuminate:
  • Red LED = turned on (note: IMU Sensors are turned on by movement)
  • Green LED = charging

Setting up the 3D Infrared Camera

1
Connect the Kinect Power Cable to the Microsoft AC Adaptor 
2
Connect the Microsoft AC Adaptor to the Kinect for Windows Hub 
3
Connect the Kinect USB Cable to the Kinect for Windows Hub

4
Connect the Kinect Camera into the Kinect for Windows Hub
5

Fully extend the tripod neck and two of the leg extensions.

Putting it All Together

1
Connect the Laptop Charger Power Cell to the Laptop Charger Power Cable   
2
Connect Laptop Charger to the Laptop in the port in the top left corner of the Laptop    
3
Connect the USB Receiver into the blue USB port on the left-hand side of the Laptop
4
Connect the Kinect USB Cable into the blue USB port on the right-hand side of the Laptop  
5
Connect Power Cables to electrical wall sockets, and your kit is set up!